Serviio on a hybrid nas?
I aqquired an MRT Nas R200 which was bricked, and the original firmware was unknown.
Telnet wouldnt play ball, but by Jtag, i could recieve this
-==================================-
Boot Loader [LOADER32 1.20e]
Press <ESC> to enter extra mode
-==================================-
SB PCI reg 0x48 = 00078006
GPIO18 = 0
Active to LAN Disk.
CPU ID: 0x0
Default MAC: 00:B3:F6:00:56:03
Initialize MAC & PHY...OK.
Default IP: 169.254.0.1
<Enter> or <New IP> or wait 1 Seconds:
Enter tftps upload mode:
Searches on other forums didnt support this nas, so i was in the dark.
I took a gamble and tried various firmwares, with no success, either kernal size too big, or not recognised.
I did some further digging, and found the bootloader was refering to an icybox, so i took a gamble and had a go with an icybox firmware..
the install worked and i got this
Enter tftps upload mode:
Upload filename: R3282_1_59b_NAS903.bin
Expected Total Size: 683306.
KERNEL+WEB, ID: KERNELWEB.
All data receive to RAM, Wait 3 seconds to continue.
Start Erase Kernel OK.
Start Write Kernel (len: 524284) .........................ok.
Start Erase Web OK.
Start Write Web (len: 158974) ....... ok.
Boot the kernel from 0x00F51000 ...
==========================================
CodeTek R32XX [NET Disk] R3282-1.59b
Hardware Version : 1007 Speed 150MHz
==========================================
System running!....
PPP software module initialization
HTTPS_Task(): HTTPS Initial done, port 80.
Line print server listening at port 515...
SEARCH_Task(): SEARCH Initial done.
Wait IDE device ready...ppp0 New Phase[INITIALIZE]
PPPOE send PADI...
retry! PPPOE send PADI...
DHCPC: discovery 3 times, Enter AUTO IP Mode.
<UPNP> UPNPAV is UP.
CMD>ITUNES_Task: Initial done.
SOAP_Task(): SOAP Initial done.
UPNP_Task(): UPNP AV Initial done.
FS_OpenDir: device not found!
SMB_Task(): SMB Initial done.
<FTPS> create C:\PUBLIC folder fail! -1021
retry! PPPOE send PADI...
DHCPS_Start: Enable DHCP Server!
retry! PPPOE send PADI...
Timeout waiting for PADO packets
ppp0 New Phase[DEAD]
NET_PppEvent(): lower layer device down!
PPPOE_Stop(): ppp0 already stop.
ppp0 Same Phase[DEAD]
It now boots to an OS, and i can access a firmware net page..
ive managed to put in a hard drive, and it says its formatted, (trying to get it on the network is a different matter though )
question is, not knowing what the original os is/was. is it worth gambling on trying to shoehorn serviio in, or should i leave well alone?
Mart