Page 1 of 1

Viera ET5 and DLNA streaming issues

PostPosted: Sat Apr 27, 2013 9:18 pm
by new2dlna
Hello,

I've recently tried to install Serviio and use it to stream some channels. Unfortunately for me, it has been quite hit-or-miss; I sometimes may get a channel or two but other than that, I usually get an error that reads "Cannot Read File" after the "Please wait a moment" prompt upon picking a stream

I've posted a log about this - thanks a lot for the help in advance

I hope to enjoy these channels and the hard work you guys have put into this!!

Re: Viera ET5 and DLNA streaming issues

PostPosted: Mon Apr 29, 2013 4:03 pm
by slyguy42o
I think this might be a profile issue. Can you test the streams in VLC just to make sure they are working properly?

I would go ahead and try upgrading ffmpeg to see if it makes a difference.

Re: Viera ET5 and DLNA streaming issues

PostPosted: Tue May 07, 2013 9:56 am
by zip
Did you try to play many streams in sequence? It looks from the log that it tries to play one stream, then moves onto another after a while. It's possible the chanel is either down or takes a long time to initiate connection.

Re: Viera ET5 and DLNA streaming issues

PostPosted: Sat May 11, 2013 2:53 am
by new2dlna
Hi guys,

I've tried all profiles - none helped

Zip, I did try to play different streams in sequence. But, I was doing this because basically it tries to connect to the stream for a while, and then gives me a "Cannot read file" error. This happens almost every time

Thanks