Serviio

Hello,

Was looking on the forum for an awnser, but can anyone point me to the right direction?
Seems all AAC 6 channel is send to PCM2.0.
Using panasonic tx50-cx800, onkyo 607 via toslink.

Thank you!

Optical connector (sometimes called TOSLINK)
This connection has limited bandwidth and can only supply
Dolby Digital (Bitstream)
DTS (Bitstream)
PCM (2 channel stereo)

Audio #1
ID : 2
Format : AAC
Format/Info : Advanced Audio Codec
Format profile : LC
Codec ID : 40
Duration : 1h 49mn
Bit rate mode : Variable
Bit rate : 640 Kbps
Maximum bit rate : 655 Kbps
Channel(s) : 6 channels
Channel positions : Front: L C R, Side: L R, LFE
Sampling rate : 48.0 KHz
Compression mode : Lossy
Stream size : 500 MiB (17%)
Title : TuGAZx Audio 5.1 Surround
Language : English
Encoded date : UTC 2014-11-11 20:28:13
Tagged date : UTC 2014-11-11 21:33:37

What profile are you using? What types of media files? Container and audio codecs? Once we know that, we can look at changes to the profile, or suggest a different profile.

I'm using panasonic 2013 config, video file format .mp4
I got this info from mediacenter classic:
Video: MPEG4 Video (H264) 1920x816 23.976fps 1964kbps [V: h264 high L4.1, yuv420p, 1920x816, 1964 kb/s]
Audio: AAC 48000Hz 6ch 377kbps [A: English [eng] (aac lc, 48000 Hz, 5.1, 377 kb/s)]

Based on the info above i added

<Matches container="mp4" vCodec="h264" aCodec="aac" />

under

<Video targetContainer="mpegts" targetACodec="ac3" aBitrate="384" forceInheritance="true">

Is that the correct way? Onkyo says DD now instead of PCM.

Yep, I think you added it correctly. If the AVR now shows DD, then I'd say success!