Illico wrote:1 ) (On serviio console disable automatic library refresh)
- Stop serviio service.
- Remove serviio.log file
- Start serviio service.
- Start movie, then wait to the end of movie to see if next movie start.
- Post serviio.log file
Ok, I followed your instructions, which is how I ran the test previously, and the log file this time was split into 6 files totalling over 3mb, the same as before. Each exceeded the 500kb limit to post on this forum, so I split the log file into 11 smaller files, and because this forum allows only 3 files per post, see subsequent posts below for the remaining files to complete the log. (wow) In chronological order, they go 5a, 5b, 4a, 4b, 3a, 3b, 2a, 2b, 1a, 1b and Serviio.log.
Note the parameters of the test:I ran the test in a dedicated folder, with 3 sample mpeg-2 files, with ac3 or lpcm audio streams as indicated:
Clip #1 (ac3).mpg [native]
Clip #2 (lpcm).vob [transcoded by serviio]
Clip #3 (ac3).vob [native]
Playback advanced automatically from clip #1 to clip #2, with no problems. Playback paused at the end of clip #2 (the transcoded clip), and I had to press "next" on the remote to get playback to advance to clip #3. Playback completed the third and final clip in the folder, and exited. Thanks again, I look forward to your assessment as to why clip #2 did not advance automatically to clip #3...